Posted by Wrench Rancher on May 27, 2017 at 06:57:19 from (75.174.189.71):
I recently purchased a '47 Ford 8n and am trying to get it up and running.
Here is my first dilemma. I rebuilt the Marvel Schebler using one of the major kits with the new jets,needles,shafts etc. I reused the brass float because it was perfect. I hooked up all the linkages for accelerator, choke and governor, turned on the gas. It fired right up but at full speed. I immediately shut the engine off and checked all my initial needle settings and fired it up again with the same results. This time, however, gas began pouring out of the air intake. Immediately I thought " stuck float" so after tapping on the carb, to no avail, I pulled the carb off again and opened it up. The Float Was Sucked Flat!
I do have another carburetor with a good float that I just installed. What would cause this to happen? I can't imagine that there would be that much suction in the carburetor bowl as to cause the float to collapse. Any ideas before I put the carb back on?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.