Posted by Fatjay on April 18, 2017 at 08:16:47 from (173.49.59.155):
The steering shaft broke on my kubota b8200 when I took it out to clear snow a couple months ago. I've spent some time since then converting my tractor to power steering. There were no universal kits available so I had to start from the ground up.
My hydraulic block had a dedicated supply and return line for power steering already, so that part was easy. The rest I had to do on my own. It was a learning process, so now that I'm more familiar, my next conversion should be much easier.
I picked up a 5 port power steering block/column from a john deere 318. They were by far the most readily available and cheapest, at ~$150. I picked up a 14" hydraulic cylinder with 8" throw from surplus center. The rest was just hoses, which my local hydraluic shop made for me in various lengths.
I took the old system out, which had the standard arm that went back and forth. Gas tank off gave me plenty of room to work.
The hydraulic flow is a bit higher than it was on the deere I guess, because it only takes a half turn of the steering wheel to go all the way left or right. Still, it's effortless one finger steering.
From now on if a tractor's steering gives me any issues I'm converting to power steering. Enough of the aching elbows from working a wheel around manually.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.