Posted by big tee on April 14, 2017 at 18:50:39 from (199.120.66.137):
Awhile back I posted some pictures of the $799.00 tree puller I bought. It came without a guard on the hydraulic cylinder or the person running it so I built both. I built the guards out of used steel and sandblasted them and hung the big guard from my gallows and painted the bottom and the wife helped me flip it over so I could paint the top--real careful. Got it painted-weather front came through, blew it over. Oh well. I don't have a skid loader but my Son has a Case 1845C so that is what we put it on. Never been around one--works good. They say--PULL TREES 8 INCHES IN DIAMETER--Don't believe it. The dirt is soft and a 4-5 in. tree gives his Case all it wants. I was so careful with the paint but after using it for a few hours it is all scratched up. The cylinder guard is sheet metal broke with muffler clamps the same size as the cylinder welded to the sheet metal. Most of the ones I was pricing came without a person guard--after running this one for a couple of hours, I would never run one without one... Thanks---Tee
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
