Posted by RBoots on March 11, 2017 at 19:14:17 from (173.241.113.102):
I have a small straight mast Clark forklift, I think it's 4,500 lift cap. It has the hard rubber tires on it, which are terrible for tooling around outside the shop, off the concrete. I want to put pneumatic fork lift tires on it, but the solid drive tires are only about 3/4" from the "fender wells", and they are real short tires, maybe only 10 or 12 inches tall at the most. Most of the small pneumatic fork lift tires are probably 16 or 18 inches tall, as a guess. Has anyone ever converted one from hard tires to pneumatic tires? How did you gain the clearance to allow the drive tires to fit in the wheel well? To me, it looks like you would almost have to either cut the wheel arch out if possible, (I haven't yet looked to see what structure is back there yet. Or, did the ones with pneumatic tires have a lift block between the frame and drive axle to gain that clearance? I think there is plenty of room for the rear steer tires to fit, just not the front drive tires. Oh, I like to use it to pick up heavy tractor stuff, front ends, engines, etc. Thanks
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.