Since 12 volts can be a bit tough on some 6 volt starter drives, its typical (for those who aren't electrically challenged lol) to use small batteries and/or too small cables etc to soften the blow and lessen that hard initial engagement since small cables drop excess voltage (I x R drop) and small batteries cant deliver such high currents. IT CAN BE A GOOD IDEA (subject to engine and how hard to crank and temperature etc) IF YOU USE 12 VOLTS ON A 6 VOLT STARTER IN CERTAIN APPLICATIONS (NOT all)
OF COURSE if you have a big engine with decent compression hard to crank, then you need proper size battery cables and a high CCA high capacity battery especially when its cold. Its only for a smaller easy to crank engines when you use 12 volts on a 6 volt starter you might use way too small cables to drop voltage and very small batteries to reduce starter drive damage.
When its zero outside and you have a 6 volt tractor on a fairly big engine YOU DONT WANT 10 GAUGE CABLES AND WIMPY BATTERIES THEN LOL
This isn't rocket science, just common sense and simple physics when it comes to what size cables and what size batteries are needed when you start using 12 volts on 6 volt starters etc and the engine size and compression and temperature all make a difference
FOR SURE desulfating is a good idea and yes it works. In the RV where I have four Trojan T-105 Batteries my Smart 4 Stage charger has an automatic desulfate cycle plus once a year I use my big charge at home to manualy run a desulfate cycle TROJAN RECOMMENDS IT
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.