Brown Swiss the way we always mixed concrete was 3-2-1. 3 shovels gravel, 2 shovels sand, 1 shovel Portland cement. I have pored a fair amount of concrete in my younger days. The entire west cattle pens here where poured with a hand filled mixer. Each yard is 100x 200. There are four sections this big. Usually took a week per section. I sure could not shovel that much any more.
We had two mixers that fit on the three point. We piled the sand a gravel out side of where we were pouring. So park one tractor/mixer by the piles and fill that one mixer up. Move it to where we were pouring while filling the other mixer. Usually four of us. One on each tractor and two shoveling, with one dumping the concrete and rough leveling it out. Every 5 dumps we would screed off the poured concrete.
We used a lot of old wire corn cribs as reinforcing wire in these floors. At the time you could get wire cribs for tearing them down. Many of those cribs where galvanized too.
I have had to cut out some sections of this to replace water lines. That concrete is harder then the ready mix stuff. We poured it pretty dry so it would not flow too far as we worked across each sub-section.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.