1.) IH 503, combine, C282 engine, night time, hired man flagged me down, said it started to shake something awful, he had pulled the threshing clutch and idled it down just before I got there. Grabbed flashlight and noted smoke was billowing from engine area. Ran up ladder, and shut it off. Engine had thrown #5 rod and broken a hole in both sides of the block, but somehow hadn't yet locked up.
The next morning, we dumped in a gallon of used oil and started it long enough to raise the platform to tow it home.
2.) 1982 Chevy C-10 6.2 diesel pickup I bought new, 125,000 miles, was driving home, heard an odd rattle or two like they sometimes do when an injector gets sticky. Got home, popped the hood, it was idling quietly, grabbed the throttle lever on the IP and revved it up a bit (they are overspeed governed, you can't over rev them), CRUNCH, I was standing at the left front, and it spit 3 chunks of wristpin, a chunk of rod, part of the piston from #3, and pieces of the side of the block (and oil and coolant) at my feet.
Thought is broken wristpin started that fiasco.
3.) At least 3 GM 6.2 diesels belonging to customers that broke the crankshaft near the front at such an angle that they still ran (and POUNDED).
4.) A customer's '89 Chevy pkup 5.7, front main bolts worked loose, crank broke in front counterweight, still ran.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.