Posted by rusty6 on October 18, 2016 at 20:26:44 from (207.195.86.42):
Went to use the old Super 90 Massey today and found the hyd-transmission dipstick missing. Tried sticking a piece of wire down the hole to see how high the oil was and could not. I found the stick had actually broken off about half inch down from the top and was still stuck in the hole. I got it out by removing the top access cover and pushing the broken piece up and out. I took my best guess and welded a stub of a spike onto the top of the dipstick. Slid a chunk of rubber up over the stick to make a sort of seal and it seems good to go. Crude and I don't really know for sure if I got the level right. I guess the only way is to drain and refill the hyd-trans oil with the recommended amount and then take a reading on the dipstick to see how close I got it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.