Posted by Fawteen on October 06, 2016 at 09:02:37 from (72.65.98.186):
In Reply to: Box Blade again posted by Bob in SD on October 06, 2016 at 07:52:54:
You'll also find a hydraulic top link VERY handy. Tilt the blade forward (front of box lower than the rear) to make it cut and tilt it backward (front higher) to drag out and smooth for the finish pass.
My box blade is narrow enough that it takes 3 passes to cover the entire width of the drive. This works well for me as I make the two outside passes with the ditch side of the box tilted down, dumping the spoil out on the center side to create the crown, then level it up and tilt it back to make a pass down the center to spread the loose gravel out.
In the Spring, after a winter full of potholes, I'll leave the blade level left-to-right, tilt it forward with the scarifier teeth all the way down and just tear the dickens out of the full width of the drive. When I have 3-4" of loose gravel across the width of the drive I'll do the three-pass finish described above.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.