1) Many dump trucks do not use scissors hoist. They use a telescoping cylinder standing upright with a dog house built around it that hooks to the floor/bed frame to lift the bed. Just a heads up. The telescoping cylinder actually is simpler in operation. You just would have the dog house sticking up inside your bed.
2) Frame rail width. The truck frame and bed frame both would be 34" wide. This is the standard truck frame width. This works great for dual wheeled axles. For regular single wheel trailer axles it is way narrower than common. I know you can order your 7000 axles any width you want but with the dump box you want as wide of wheel base as you can easily get. It makes it more stable when dumping.
3) Most dump truck hydraulic pumps are transmission driven. They usually turn around 1000 RPM. I don't know if your planning to use a gas motor driven system. Power it with just your tractor hydraulics ( the oil capacity of most tractors is not enough for a telescoping cylinder the size used in most dump trucks) Most factory pickup pulled dump beds use electric driven hydraulic pumps to lift.
All of this means there may not be as many useable parts as you think on the used dump truck. It all depends on what/how your planning to use it.
P.S. I have done what your thinking of doing. Kind of. LOL I have two that we built just to pull with larger tractors. So basically we just removed everything forward of the bed on the frame. We then just cut the frame and angled it in to a clevis hitch. The first one I ran the dump truck hydraulic pump with a PTO shaft from the tractor. The second one had a smaller scissors hoist so I just plumbed it to run off the tractor hydraulics. We almost never pull either of them with any tractor under a 150 HP. So these tractors have the hydraulic oil capacity to dump the single acting cylinder.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
