Posted by Kenster on August 05, 2016 at 11:59:15 from (107.77.72.123):
We had our septic tank emptied yesterday. The top sits about two feet deep in our sandy soil. It's made of fiberglass, or at least the top is. When uncovering it, a couple of smallish holes were found. The biggest about three inches diameter. The guy was able to pump it out through the hole. He never uncovered the lid. He said the tank should be replaced and gave me the names and number of four local people who do such work.
I guess my question is: Do you really think that we need to replace the whole tank? It probably won't need to be emptied again in our lifetime. (we're 64) It's been ten years since it was last emptied and was only about a foot deep in sludge. It's a 750 gallon tank. I'm thinking we could just cover up the holes with something and cover it up again. Why pay a couple thousand dollars to replace the whole tank? And, if we do just cover it up, what should we do about the two or three small holes? Patch them somehow, or just lay something over the holes and bury them? I suspect the holes were caused by the guy digging around to find the lid, so I doubt there are any more holes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.