Posted by diesel833 on August 04, 2016 at 12:29:19 from (38.109.191.30):
I have a late 60's Ford 3000 Gas 3-cylinder that the governor linkage is giving me issues. The good - The tractor starts, runs and idles perfect. The bad - When you throttle the tractor up, there is zero movement from the governor arm that is attached to the throttle shaft on the carb until it gets to about 2/3rds throttle. So the tractor will literally jump from idle to 2/3rds throttle, you cannot get it to sit in between unless you bump the governor arm with your hand. It then works as it should from 2/3rds throttle to full throttle as well as when you reduce the throttle down to idle. What I know - Both springs are in place on the linkage (the larger one that attaches to the manifold and the one near the governor lever that only has a hook on one end.) Also, there is not a bind in the throttle shaft (it's brand new and moves freely) and I have lubricated the governor arm and it doesn't seem to have a bind in it as well. I have also made sure every joint/ connection on the throttle linkage is lubricated and moves freely. Could this be an issue with adjustment of the governor or the linkage? I don't see anywhere that the spring tension on the linkage can be increased (which seems like it would correct the issue) and I'm at a loss. Can anyone provide me some insight on this?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.