I do not know where the "bad" reputation on the JD 566 baler came from. They where rock solid around here. Find a JD 566 with the MEGA pickup. NOT the MEGA WIDE just the plain Mega pickup. It has heavier teeth and drives over the regular pickup. The JD 566 over he JD 535 is mainly the mesh wrap system and monitor. The JD 535 is a mechanical/hydraulic system. The JD 566 is electric with actuators. If you do not switch from twine to mesh or change bale size much then the JD 535 would be fine IF you can find a good one. They are getting older. The JD 566 has a much better monitor if your changing bale size and switching from mesh to twine often.
We do custom baling so we put a lot of bale through a baler. The JD 535 balers took some playing with to get the right amount of mesh on when you switched from twine to mesh. Also in the fall they would put more mesh on in the mornings and less on after the oil warmed up. So we had to adjust them during the day. The JD 566 you can set the wraps you want and it will constantly apply that amount of mess wrap.
It would be hard for me to go back to the JD 35 series balers. The heavier pickup and better monitor just make baling so much easier.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
