I never use one, and if you try my method, you won't either. Lightly snug the pressure plate up so you can still move the clutch plate, then position your best eye dead center of the pilot bearing (use a good light). Move the clutch plate around until you see concentric circles. If you are centered you can see both ends of the pilot bearing, and when everything is aligned like a bulls eye the clutch plate will be in place better than with a tool. You can get it within a few thousandths.
Then tighten up the pressure plate. The other thing I do is align one of the splines where the side of a spline is right at 0 degrees at the top. Then align the input shaft from the transmission vertical to match. When I was a kid I would hold a three speed up off my chest with one hand and try to turn the output with the other to get the splines to match. The first time I tried to align the splines before I stabbed the transmission it went in so quick first time I couldn't believe it. Same thing with a tractor, get everything aligned and it will roll right together, assuming you have a flat floor to work on. It's a little tougher under a tree on boards.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
