I have worked through it, and have used it for 14 years, and it doesn't owe me anything at this point, so I have tried to forget- but............
I bought a Ryder "road ready truck". The first thing I did was shorten the wheelbase. I found the rear axle housings had been welded. I used it that way for years, before I found used ones and had them replaced. I got that done just in time, as the forward housing had cracked enough one wheel ran crooked- when taken apart the differential needed rebuilding.
One of the "new" recaps on the back blew out, fortunately close to home. When my tire man looked at it, he commented on how he could never get away with capping a tire that old.
Upon draining the engine oil, I got flakes of metal. The bearings were falling apart! I measured one of the worst ones when replacing them, and in one spot there was .017" material gone! My VERY experienced Cummins man said he had never seen bearings that bad come out of an engine still running. He said they had some trouble with British bearings. Sure enough- they were made in England.
The head gasket blew, away from home, loaded. I got towed home. Took the head to the engine shop. The said they had never seen a head with that many cracks! Said it looked like a spider web.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
