Posted by Paul from MI on January 05, 2016 at 19:59:17 from (204.106.248.120):
In Reply to: chain saw sharpeners posted by longmeadowfarm on January 05, 2016 at 14:08:14:
I built my sharpener copying the geometry of a Belsaw sharpener. I use worn out surface grinder wheels from work, #46 open grit wheels. They don't burn or overheat the chain. Maybe most of the overheating issues are caused by the wrong grade wheel? The HF grinders I have seen lack the rigidity of the professional grade machines, which makes them sensitive to operator technique. You can still o a good job, but it takes more skill. The only time I ever remove more than about .004" from a chain is if it has hit a rock or some iron. Then you have to take enough metal off each tooth to return to the original contour to make it cut right, an most likely will need to file the rakers too. I can usually use a chain down to when the teeth are less than 1/4" long, so I have no idea how many times I sharpen them before I throw them away, but it's a lot. And I use a caliper to be sure teeth on both sides of the chain are the same length. Keep an eye on the chips when sawing, if you see any sawdust, change or sharpen the chain. I'm not a hero at this, but I've been doing it this way for over 40 years and it has worked well for me.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
