Posted by showcrop on November 12, 2015 at 03:27:45 from (208.93.198.100):
In Reply to: Steering Wheel posted by Spudm on November 12, 2015 at 02:59:00:
Can you post a pic of it? There are a lot of different methods, depending on how badly it is rusted on. First is penetrating oil and time. This has worked for me so far. Next would be removing the nut and any washer and replacing the nut with one that is thinner, so that you can hit the nut and the force transmits to the shaft and not onto the wheel. Give it a sharp blow but not enough to damage the shaft or housing. If you can have someone pulling up on the wheel while you hit the nut it is more effective. A strap around the wheel supported from above through a come-a-long or a load strap can take the place of a helper. I think that I read this one in a manual. Next would be a puller, which of course would have to be of the three fingered type. Effectiveness of pullers is enhanced by striking the puller's bolt head with a good sharp blow when it is good and tight. If none of the above are successful, you may need to resort to cutting it off with a torch or grinder.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.