If there is an adjustment/ packing gland on the rod seal it means the cylinder uses chevron style packing -vs- the newer lip style polypacks. That said, you do not have to disassemble the cylinder to reseal just the rod. All you need to do is take the adjustment piece loose, and dig the old packing rings out. Once you've got them out, get your local hydraulic shop to get you a replacement set.
Going back in you take the new rings and cut them at a double angle, meaning angled top to bottom and left to right. Do them just like you'd do piston rings and stagger the cuts as you install them. Once you've got all the rings in tighten the adjustment nut (packing gland)just past snug. Move the cylinder in and out a few times and tighten a bit more if it leaks.
The chevron style packing has a relatively high tolerance for imperfections in the rod because it has multiple sealing surfaces -vs- the single sealing surface of a polypack type seal. In other words you shouldn't need to change the rod to obtain an acceptable seal for a relatively long period of time.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.