Posted by Bryce Frazier on June 07, 2015 at 19:49:43 from (67.142.182.20):
WARNING! YOU ARE ABOUT TO READ ABOUT A "FARMER FIX"!! PLEASE READ WITH CAUTION!
So, as you all know, there was this large hole in my Farmall where the Hydraulic pump SHOULD have been:
Sooo, I was not about to spend $50 on one of these little guys, NOR did I feeling like waiting over a week for it to get here, so, I got creative...
Took a piece of 1/2 inch plate steel (from old stuff in the scrap pile), cut it down to 5 inches long, and 1 3/4 wide. Then ground the ends down so that they would properly fit in the slots (show above), then put it in place.
Well, that was all fine and dandy, but it clearly would not stay there, so, I opted to put a radiator hose clamp around each end to hold the "new" drive shaft in place in the lugs!! :)
I know some of you may will be disappointed in me for not buying the correct part, but on the other hand, I encourage you to see the resourcefulness in today's adventure... Imagine if this had been an emergency, or I NEEDED to get back in the field. I CAN do this! :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.