Posted by oldtanker on April 25, 2015 at 17:17:57 from (64.118.3.19):
In Reply to: Don't rip me off posted by 37Chief on April 25, 2015 at 13:47:43:
When I worked as a mechanic in a small 2 man operation my boss was a real good guy. We had a lady come in with a repair estimate from another shop. I was just finishing up a bill when he showed me the estamate. I started laughing. The lady got upset thinking I was laughing at her until I explained to her that I was laughing at the audacity of the guy who wrote it. We explained to her that at least she smelled something wrong.
A mechanic who worked at another shop was doing after hour work out of his shop at home. He was telling customers "while I was doing (name repair) he found something else that he could do cheaper than his place of work could. I know the shop owner well and know he's not a crook. I took the estamate to him and watched him tell the mechanic in question to pack his tools and get out.
The repair in question? Replace the pinion shaft seal on the rear axle of a front wheel drive car.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.