Posted by Bill VA on April 20, 2015 at 14:40:31 from (76.3.243.86):
I see these old videos of Farmall H and Deere 2 cylinder tractors outfitted with mid-mount and sometimes front mount cultivators - tooling down the fields, cultivating. I gather the farmers are knocking out weeds, maybe side dressing or hilling the crop or maybe all three. I assume round-up ready crops like corn were not invented at that time and some kind of cultivation was necessary and a tractor with cultivators was the way to go in absence of some chemical solution and faster/lower cost than a team of men with hoes in hand or a horse with culitvator.
But then in the very late 50's and early 60's - something changed. Deere and IH go big on their tractors, i.e. Deere 4020, IH 806, etc. Wide front ends. Was this the end of crop cultivation by a row crop tractor? I can't say I've ever seen a midmount or front mount cultivator on these tractors.
What happened??????
What caused the narrow front tractors like the Farmall H tractors to no longer be needed on the farm? Did row crop cultivating stop with these new bigger tractors? Surely round-up ready corn wasn't around at the time? How did the farmer control weeds, etc., with these new larger tractors and aside from products like round-up ready corn, how do they effectively keep the weeds to a minimum today?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.