Posted by JD Seller on February 20, 2015 at 19:30:38 from (208.126.198.123):
In Reply to: AR rear axle removal posted by JDBRIDER on February 20, 2015 at 10:05:19:
What will not loosen??????? The axle to the wheel hub or the axle to the spur gear??? It makes a difference to how you loosen them.
If your having trouble getting the gear unstuck off the axle here is trick I have used for years.
On the old two cylinders the rear axles are not that far apart in the housing. Loosen the nut on the axle your having trouble with. DO not take it off!!! Leave it on to where it is not out past the end of the axle. Then find some steel flat that will just fit between the ends of the two axles. I usually use one of my hydraulic press push plates and 2-3 inch wide 5/16-3/8 steel. Now that you have some steel spacer back the nut off until it is pushing against the flat steel. Your using the nut like a reverse puller. When you get it tight than go to the side your NOT taking out and hit the end of that axle real hard. The shock wave with transfer to the stuck axle. This will usually pop them right loose.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.