If it's JIC fitting on the end of the line, they make a compression type fitting that will go on a line and turn the end of a square cut tube into a JIC connection. I know they make them for the larger sizes as I used them making up a bunch of 3/4 lines on the back of a loader bucket, but I don't know how small they go.
Unfortunately I don't know what they call the fitting either. In my case I had intended to flare the ends since I have the tool to do so, but the guy at my local hydraulics shop suggested them as an easier, and faster alternative. He got them for me, and I put them on, that's about as far as I knew anything on them.
In your case this would give you the little bit of added length to make up for the end being broken off, and allow you to do it without having to take the line off....if they make them in the right size.
Barring that, I have cut lines and brazed a JIC end to them and had a short line made up. Basically this is the same thing that has been suggested in another post. In my case I just brazed on a fitting because I was in the field and didn't have a way to get the compression fitting, in the other post, needed to do it that way. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
