One guy says it is the throttle body (that you just paid to fix). Another says it is the distributor. Yet another says it is the EGR. HOLD ON!!!!!
Pulling codes might tell you something. However, the older OBD1 systems were a lot less complicated than the newer systems, and a lot less sensitive. Getting a bit of understanding about the system will help considerably. As you can see, the "shotgun approach" is expensive and ineffective. You already spent a small fortune, and it is still not working right.
The system is basically a feedback system. The main important components are the OXYGEN SENSOR, the MAP SENSOR, and the INJECTOR BODY.
The injector body (throttle body) contains the injectors, throttle position sensor, and fuel pressure regulator. If it has been rebuilt and verified, it is likely NOT the problem. That can be verified by checking the fuel pressure and observing the injectors. The fuel feed can be observed from above. It should look like a fine mist coming from each injector in a fan shaped pattern. No droplets or drips.
A bad OXYGEN SENSOR can cause the engine to run rough and rich. The system is a "feedback" system. The primary mixture control is feedback from the O2 sensor to the CPU. MAP sensor (that has been replaced) is secondary, and is more important in open loop than in closed loop operation.
A worn distributor shaft will usually result in rough running to a no start condition depending on the amount of wear. This is a condition that would come on progressively over a period of time.
All things considered, I would discount the "short answers" given by some because there is NO SHORT ANSWER. If it was the same problem each time, there would be no need for repair shops or mechanics.
Sadly, I have a few tools that might help you out. I have several older OBD1 scan tools that allow you to read sensors "live" on GM products. If you are still stuck, maybe I can send one to you. I no longer use or need them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
