We do it, but only because we have heavy ground and hay season was too wet too often to get enough of our own off this past summer. We ended up buying some 5' rounds of first cutting mixed grasses from a guy who farms on gravel a couple hills over, but we don't have equipment to stack them or a good place to store them. They get peeled/unrolled by hand, baled with an IH 46 (usually powered by our SA), then put up in the mow. Works best with 3 people - one unrolling, one feeding the baler, and one clearing the output end. It's a lot of work, and makes for a goodly bunch of chaff (that goes to the pigs). The bales themselves seem to turn out ok.
If you have far more time and round bales than you know what to do with, if there is a better market for small squares than big rounds, and you aren't looking to make much money for the time, effort and fuel invested, go for it. Then use (or go buy) a square baler for next year to save more than a few steps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.