All of which shows that some people will try to give a short answer - even if it is wrong - or unrelated..... My humble opinion: Instead of short one-line answers why does nobody suggest DIAGNOSTICS????? I have nearly preached this on this forum as well as others. Just throwing parts at the problem is the most expensive and inaccurate way to deal with ANY mechanical problem. The man should start with the BASICS! Compression test (before pulling it apart again). Check and correct as necessary the firing order. Check for vacuum lines that may have been disconnected and/or left off. Run a scan for codes. That may point you towards something that did not get reconnected properly (like the MAP sensor on the back of the upper manifold).
A point of information..... That particular engine has a "rat's nest" of wiring and vacuum connections on the back side of the upper manifold. Easy to get things improperly connected. Best procedure is to disconnect the "dog bone" mounts on the top front and rotate the engine forward for access.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.