Posted by Mark Robke on July 23, 2014 at 18:45:09 from (75.117.217.13):
In Reply to: Any ideas? posted by NCWayne on July 23, 2014 at 14:40:50:
Is this one the thrust bearing? Does the crank need to go forward or backwards to fit the thrust surfaces in? Does the old bearing go back in at all? I used to use a cotter pin that fit in the oil hole and had the ends bent out to each side; I would work the bearing in as far as it would go and then rotate the crank til the cotter pin ends caught the end of the bearing and push it on in. I remember a few that seemed to need some force , but they went in.The ends of the cotter pin need to be matched up with bearing pretty good. Sometimes the bearing will go in good with just finger pressure,but some are pitas. I mostly used the bent cotter pin to roll them out, but it will push them in.Good luck; let us know what works.Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.