Posted by rrlund on June 20, 2014 at 12:46:32 from (162.250.26.144):
I knew when I bought that Vicon discbine that the conditioning rolls were rough. I went out and tried to cut with it yesterday and it was spitting more and more pieces out as I went along. After about four rounds it's was so far gone that all it wanted to do was wrap. I ended up taking the rolls right out. It makes a heck of a nice trailing disc mower. The hay's heavy and down like I haven't seen in a long lot of years,but it seems to be shaving it right clean to the ground. Only trouble I can see right now is,the hay isn't even hitting the deflectors and it's laying about an eight and a half foot swath from a nine foot cut. Good for drying maybe,but probably not for raking. I'm going to cut a piece of steel and see if I can put a deflector right close to the far end disc to get at least a little bit of a gap between the swaths. Oh well,it cuts to beat the band and I don't have much in to it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.