Posted by Hal/ Eastern WA on June 13, 2014 at 20:56:21 from (97.114.102.115):
In Reply to: Sickle Mower Teeth? posted by Bryce Frazier on June 13, 2014 at 15:15:42:
If you need guards, I would suggest taking one with you to make sure that the replacement is EXACTLY the same. I had bad luck buying guards at Big R. The ones I bought LOOKED like they were the same, but would not fit. The bold hole was slightly too close to the ridge. I ended up going to New Holland to get guards that would fit right on my 501.
Sickle sections were easier to find, and the ones I got at Big R worked just fine. You going to use bolts to fasten them on, or rivets? Bolts seem easier, but I have always used rivets. Kind of old school.
While you are there, you might consider getting some wear plates too. New wear plates really helped my mower. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.