Posted by Rollie NE PA on June 02, 2014 at 18:10:29 from (108.57.62.180):
I have an H 6 volt, positive ground that I can't get to charge. New battery, new regulator, new ammeter, new wires and a 3 brush generator that just came out of the shop. All the connections are clean, the regulator mount is properly grounded, polorized the regulator but still no charge.
I was just talking to my friend and he asked me where I got the generator and I really am not sure.
He thinks maybe the generator is ment for mounting on the other side of an engine and thus it is turning the wrong way. My friend just called me and said according to what he read that when you polarize the regulator, that would take care of the rotation issue with the generator. With the tractor running and the wires disconected from the generator, I should be able to get a reading from the A terminal correct? Do I even need a voltage regulator with the 3 brush generator?
This post was edited by Rollie NE PA at 18:26:58 06/02/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.