Posted by Leroy on May 09, 2014 at 07:47:25 from (69.88.207.185):
In Reply to: Oliver plow ID? posted by Banditfarmer on May 09, 2014 at 06:03:58:
I like those bottoms, same as Dearborn had on the econmy series plow. Only thing I did not like was could only get a plain blade type when should have been avaible to get a rock type share with a nose. I had them on a clutch lift plow that did not work good behind the A Deere, would have worked OK behind the AR Deere that was of the wheel tread for that Oliver hitch and the A was too wide. Pulled easy. Now that frame is adjustable for 12", 14" or 16" spacing and mine like that was set on 16" spacing with 14" bottoms. You could set it to 14" and would work OK with those 12" bottoms but stay at same depth and not go to the deeper depth the larger bottoms are usually run at. We pulled ours with a 3 cylinder Ford 4100 but it was used when we bought it a I think a 1600-1650 or something like that. You copuld get either a cat 1 or cat 2 hitch and we had cat 1.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
