Posted by rla on February 24, 2014 at 16:51:44 from (69.35.177.185):
In Reply to: chain saws to buy posted by jbk on February 24, 2014 at 09:53:57:
I think you've done opened up a can of worms. I believe there are many good saw's out there one could buy.. The problem with most of us we don't run a chain saw 365 days a year. Sometimes they sit for months. I believe the more they are ran ( correctly ) the better luck you will have with that saw. I personally have a Husqvarna is my newest saw, because I have a local dealer. I still have a Poulan have had since 1985. The Husq design clean's it own air fitler & I can't say the poulan does that with flywheel air. I've taken care of, used the correct mix & keep rolling the bar over & keep the nose greased. My 460 Husqy will cut far more wood than the Poulan ever did on a tank of fuel. I've had good luck with Pioneer Homlite Pouland & Husqvarna. The Stilh I had was a Lemon, but I've had friends that have stihls & Have used Stihls that cut & ran Well.
I cut 8 Loads of Wood a winter season each load is close to a full cord, I also cut for my two daughters wit the help of their Husbands another 10 cord or close to it. I use a portable mill from time to time in teh summer months. Very seldom that my saws don't run every week.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
