Posted by andy r on February 19, 2014 at 19:56:05 from (75.91.149.15):
In Reply to: Oil pressure gauge posted by rohdog50 on February 19, 2014 at 16:23:29:
The best thing to do is see if you could hook either the new oil pressure gauge or another known good pressure gauge closer to the fitting where it comes out of the engine without all of the plastic piping. The gauge might be reading right???? Like was said in another post you don't necessarily need super flow at the gauge - just the pressure which will eventually build up even if there is a slight restriction. Remember the oil isn't going anywhere at the end of the line so it will build up eventually to engine oil pressure. If the oil could flow out of the end of the line the pressure would be nearly zero since there is very little flow. Massive flow out of the engine block doesn't mean massive pressure. Best bet is to measure the pressure at the engine with a known good gauge without all of the tubing as a precaution. A good farm or hardware store might have all of the fittings to do so for a temporary check. There are some known problems with the inexpensive gauges being accurate. Good luck - I understand that it can be frustrating.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.