I've recently done this and will share what I learned.Take lots of photos you will refer to them as you start to reasemble. Stack each wall section metal in identifiable stacks. Find or make long pallets to stack your metal on. Do lots of measuring inside. Note the height of all girts, framing around windows and doors. Check the dimensions of the purlins from the peak of the truss down to the eves. All of this so that you can reuse all of the screw/nail holes. If the bldg has insulation under the skin, use ppe to avoid inhaling the fiberglass/dust/molds that will be there. We rolled up and stored and reused. It is expensive to replace but makes a much tighter metal bldg. I hired experienced carpenter friends, rented a Lull to take down trusses and pull poles, paid for fuel to get it all home. Ours was 48x110. Took down, loaded and delivered 280 man hours. You will end up with a good bldg, at about 1/4 the cost. gobble
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.