Posted by NCWayne on January 04, 2014 at 18:53:29 from (173.188.169.54):
In Reply to: OT. Ford truck posted by tomturkey on January 04, 2014 at 17:35:07:
One question not asked so far is does it have a tilt wheel or a fixed wheel, as it makes a big difference. I"ve got an "87 Ford truck, with a tilt wheel, that had a similar problem, twice. I"m thinking that mine and yours are the same. That said, the first time mine was simply hard as heck to start, especially when it got cold. It wound up getting harder and harder until it simply wouldn"t start. In that instance it wound up being a piece of tape off the wiring harness going up the column that had gotten wrapped aroud the rod that another post talked about. The tape eventually got into the switch itself and pushed it apart so it wouldn"t start.
The second time, I think was a result of the first problem. What happened then was in a tilt column there is a arched piece of aluminum with a "guide rod", pin, etc that carries the movement of the lock cylinder through the tilt part of the column and on to the rod that goes to the switch. I think the force to overcome the tape on mine the first time cracked the piece and it eventually failed. I called around and everyone said they didn"t make one so I took a piece of steel and machined my own. Several months later I was in Oreilies looking for something else, and they do carry them. To change the piece you have to pretty much disassemble top end of the column and get the hinge part off. Once the hinge part is off it also has to be disassembled to change the part. Just be careful when you pull the pins holding it together, that the spring doesn"t go flying. Hope this helps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
