Posted by Texasmark1 on December 28, 2013 at 16:07:20 from (172.242.14.143):
In Reply to: 467 Haybine posted by Steve Rkh on December 28, 2013 at 14:08:36:
I think I had one of them. Got tired of not being able to grease the zerk at the far end of the drive line (at the ujoint in front of the slip clutch) since it had an enclosed drive shaft. So I got my torch out and cut a 12" hole in the side and had no more problems. Probably a 6" would have worked, but I did the big one for spite.
Other thing I didn't like about it was to move from the road position to the cut position and back, I had to take along a piece of cinder block to block the right rear wheel. Swore I'd never have another so I sold it and bought a JD 1209 with an open shaft. I don't know how you put up with it.
Ok I had my venting session. Sorry; on second thought, naw. NH deserved it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.