It is still possible to plumb your 135 with remotes even it has no auxillary pump. But you do need a diverter valve in place of the transfer plate on top of the lift cover. To use both the lift and hydralic top link with out a lot of switching at the diverter, take the feed supply from the diverter to the input side of the spool/remote block, take a return to the small allen keyed bung on the left side of the lift cover, just in front of the cross-shaft. Then plumb your single acting remote into the bung on the right side, just below the diverter valve and take your spare valves to quick attach couplers at the rear of the tractor. To use, simply turn your diverter to the remotes and put the tractor in constant pumping and leave it there. To operate the 3 point use the single acting spool, use the other spools as normal. I like to use a quick attach on the line from the valve to the right side of the lift cover. That way it can be used if you need to operate a single acting ram or if you need to plough and use the draft control, it can be disconnected and the diverter switched back to operate the 3 point as normal. I have fitted this system to many 100 series tractors and it works! Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
