Posted by George Marsh on November 06, 2013 at 09:37:48 from (64.12.116.16):
In Reply to: Concrete block wall posted by Brad Buchanan on November 06, 2013 at 06:56:43:
Brad, I've only put a up few block, but put over 20,000 brick on my house.
I would recommend getting a mixer. No fun doing it by hand.
I THINK there is a top side to the block, the side that is bigger, hold more mortar. If not, I do it backward, but it works for me.
I set up corners with a post and pull a string when doing brick.
I used a 4 ft level to keep my work as level as possible. Thay way you can level 3 block together.
Like everything, it works better if you start out level and square. I have a self leveling laser transit. Some will call it a laser level. All I know is it's nice to have to keep block and brick level.
I've never done this, but it's one of those things you may want to try. Some people use shims they can remove after the motar sets up. This way if your motar is a little thin, the block mashes down and rests on shim. I've heard some people use marbles to get a uniform motar joint. They leave them in motar. Again, I've never done it but some people say it works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.