Posted by picassomcp on October 24, 2013 at 19:33:09 from (50.107.42.233):
I have just finished my 3rd season of making hay off of a few pieces that had hay on them when I bought it. I've just continued to make the hay that was already there. The crop has thinned, I'm sure the stands are getting older. I'm thinking about plowing up a few of the smaller pieces and reseeding them into some better hay. I talked with a friend about this, he didn't recommend plowing up hay then replanting hay. He said I should put a different crop in for a few years then go back to hay. Would you recommend the same??
I've only got hay equipment, I do have a plow, disc, drag and a drill, so replanting hay would be easy enough. I don't have a combine and really don't care to take on that expense and maintenance to do a few acres for a few years until I can get it back into hay.
Or, should I just fertilize the pizz out of the current stand? Its getting pretty grassy, but does still have some clover and other varieties of hay I don't recognize. I feed my hay to beef cattle and sell some hay that goes to horses. If the grass isn't hurting anything, why plow it under?? Honestly, I haven't put any fertilizer on these pieces in the 3 years I've been making the hay, could be all it needs is fertilizer? the last 2 years, we got very little rain in August, both years it just killed my 2nd crop production and I didn't get a 3rd either year. Just looking to get a little more production out of my acreage, I'm willing to put some time and money into increasing production, I just wanna put it where its gonna make the biggest difference. This is Central MN, a 1/2 hour east of St. Cloud.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.