I am not yet sure on GPM or apparent load to the motor. I am still trying to determine what torque and rpm is required. I do now that a lot of motors run at well over my desired speed which would probably be 50-100rpm. The motor may not have to be all that big with that kind of torque amplification.
I do have a complete hydro pump, tank, motor system on my hydro swing that just runs perfect but certainly does get too hot to touch. Not sure why a tractor would care either way but I don't want to hurt the tractor for sure!
I just cannot get over the cost of these PTO pumps! I am not sure what the capacity is of the one on the hydro swing but it SWEET! Cute and runs a decent size hydro motor that runs the reel, sickle bar, and conditioner rolls. I would think that would be plenty! Just need to find one cheap enough if I need to go that way.
I do have thoughts and plans to mate this to a smaller tractor for pro services in tight spaces where typical well rigs cannot get. I know I can get business just by being the go to guy for backyard wells.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.