Try "rustmort" It's a phosphoric acid based converter I think. I can go check, but, get it sandblasted and then rinse with a ton of water. after that, apply rustmort with a brush or a windex bottle.
Rustmort is the best thing you can do after you triple rinse. It's all about flushing away every bit of it. Water doesn't hurt bare steel nearly as bad as any chemical in conjunction with water. Getting the calcium away is key, and water is the answer. I know it sounds stupid to dowse bare metal with water, but it really is the best thing. Those pits contain a lot calcium. getting them clean and then water with a hand wire brush and flood the driveway if you have to. that's the way to go. Lot's of good tips in this thread. I owned an autobody shop for 9 years, close to 18 years professional experience...
That is what I would do. treat bare metal with additional sandblasting, followed by dry scrubbing and air from a blow gun. You have to get the sand off the metal. Then a good epoxy primer(if you can find someone with old style lead based epoxy primer, you are good) Try some PPG DP-LF primer on all the bare metal, let it cure, then follow up with a build primer. That si the best way to get it to last. It's all about flushing with water and scrubbing. You have to get all the pockets of rust killed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.