Posted by welding man on July 24, 2013 at 18:19:33 from (76.9.224.70):
In Reply to: Re: Oil consumption... posted by Robert Major on July 24, 2013 at 16:19:11:
Robert. I would love to do a few for that price. I have never charged anywhere near that for a rebuild and no I don't do inframes for anyone. I can buy a complete master rebuild kit for that engine, with new pistons, sleeves, rings bearings, valves,springs, guides and keepers all gaskets and seals and oil pump for less than $500.00. I do all my own machine work except grinding the crank,if needed.I can pull it rebuild it and put it back for about 1000.00 to 1500.00 labor. If the pump and injectors need work,another 800.00 to 1000.00. Oil-filters and antifreeze-hoses etc another 150.00. Gas engines are cheaper.I do 8N fords all the time for 1200.00 to 1500.00 bucks. Either you paid too much or I'm too cheap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.