Posted by John B. on July 02, 2013 at 16:02:17 from (50.40.110.66):
I bought me a little one bottom subsoiler 3 weeks ago and I decided to make a bullet/enlarger for it. I finally decided on how to make it. I bought a plastic long neck funnel, cut part of the spout off at the bottom, bought a long eye bolt and a quart of resin with hardener. I put the eye bolt thru the funnel, mixed up the resin with the hardener then filled the funnel with the mixture and set it upright in a small bucket for a few days. This is how it turned out. I welded a small flat bar on the back end of it today. (The weld doesn't look good I know). I hope this bar will tell me where it is incase the assembly breaks loose from the ripper out in the field. I'm going to leave the plastic funnel on it, I thought this will help hold it together. I'm going to use a short chain to connect this to the ripper.
So Do You Think This Will Work???
It's been too wet here to try it the last few days. I can't wait to give it a try. I have about $40 invested in this little project...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.