I'm with ACG, get the instructions from the manufacturer and tell your installer to do it by the book or find someone who will. If it were me and I was a lot younger,I would take off all the old shingles,take off any large mouldings around the edge of the roof like old houses have put 5/8"plywood on the roof NOT osb,manufacturer will not warranty over OSB. Then the screw used for plywood is different, bigger dia. and shorter. Then make sure you put on all the trim strips that the manufacturer recommends no bending the roofing down over the edges. But since I'm over seventy I'm hoping this lousy roofing job, 1X4 over three layers of shingles with the roof edges poorly nailed into 4" cove moulding that was done just before I bought this place lasts longer than me. Then again if you're a young man go with the standing seam. Part of this 150 year old house of mine has the original standing seam roof on it. stamped on the back side it says guaranteed until 1928.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.