Posted by Texasmark1 on March 02, 2013 at 11:03:20 from (184.63.52.151):
If you have a baler belt clamp fail, why can't you just cut it off and install a new clamp?
My current belts are connected with Clipper Wire Hook terminations. Belts are 7" 3 ply diamond, 402" long (JD 375).
I have a couple with about 1" or so that has worn out and is no longer connected. The remainder of the 7" width is in very serviceable shape.
The actual part of the belt being currently used is 1/2" on each side for a total of 1" of belt length.
If I were to have a problem and just cut off the existing wire clips, prepare the surface and install a new clamp, I would only shorten the belt by 1". With a length of 400" that's only a length reduction of 0.25%. I'd bet the belt stretches more than that as it wears in.
So, question is, what's the big deal? Will it work?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.