Posted by Hoosierhog on February 21, 2013 at 07:03:16 from (69.130.191.125):
just curious if it is possible to raise the height of a pole building. my shop is a 24x32 x 9 and with the over head door its tight to get my ford 4000 in there. i also have an issue with the concrete floor sweating and it has flooded only 1/4 of an inch and only 1 or 2 times since i've lived here but i was thinking. if i striped the building and back filled 6 - 8inch thick pad of gravel then built my barn back using the existing trusses, perlins, girts and headers. the barn needs a new roof and it needs a vapor barrier so that needs replaced any way. but i was thinking of using sister posts and making it tall enough id have 12ft door clearance and adding an enclosed lean to on one side to give me more square footage. i would reuses any metal i could and i have a good source for cheap or free lumber not to mention i've been hoarding material to renovate this biulding for a while. so other than the vapor barrier , concrete, fastners and some metal and doing the work my self i think it would be cheaper than biulding a new shop. so what do you all think is it possible, is it cheaper to do it this way, what is your opinions.
oh it also has 4x6 posts and 8ft spacing if that makes a difference.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
