Posted by JML755 on January 27, 2013 at 06:09:45 from (24.192.222.226):
In Reply to: OT: hardwood flooring? posted by mike henry on January 27, 2013 at 00:00:30:
mike henry,
I just installed over 900 sq ft of 3/4" red oak hardwood on a osb sub-floor and 15# tar paper as a moisture barrier. Lumberliquidators.com website has instructions online, which will help you determine installation method for whatever product you choose. Personally, I like the 3/4" product over the laminate. The house we just bought has a laminate product in the kitchen right next to the new hardwood floor and there's no comparison. The laminate looks "plasticky" and there's a major difference in how it feels when you walk on it. But...... the 3/4" oak requires more skill to install and if you get the unfinished (as I did) you've got to sand the floors and then finishing takes a day or so plus it takes up to 2 weeks to fully cure the finish. They do make the 3/4 in pre-finished so that's an option.
BTW, We were going to leave the kitchen alone as the floor is not in bad condition but after putting in the new 3/4" floor, we've decided to replace the laminate with red oak. The laminate product the previous owner used is not glued down. It's floating and it will lift right up with a shop-vac at the edges.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.