Posted by Hal/Eastern WA on January 16, 2013 at 16:40:30 from (97.115.181.136):
In Reply to: shop mezzanine posted by mjsnodgrass on January 16, 2013 at 11:36:46:
I built a mezzanine (always wondered how to spell that word!) in my attached garage, which has a 12" ceiling. I built it over my work bench, so I made sure it was high enough for almost anyone to walk under, so it is a bit low for walking on top of the mezzanine comfortably. I used 2x6s to construct the framework, using joist hangers. The beam and support posts are triple 2x6s and I used 3/4" wafer board for the floor, so it is plenty strong for the kind of stuff I store up there. It is 6" wide and 30 feet long, with a connection to the landing of the porch into the house.
The mezzanine has been real handy for storing all kinds of stuff, like tires and boxes of this or that. I don"t put anything real heavy, like engines or transmissions up there, as I don"t have any good way of getting them up there safely. But I bet the structure would handle heavy items just fine. The underside of the framework is also real handy for storing longer items, as I added some plywood to make cubby holes between the underside of the floor joists.
In my garage, the area above the workbench was more or less wasted space. I had to build the garage as high as it is to make it attach to the existing house correctly. The mezzanine has helped me make use of some of the wasted volume in the overly tall garage.
At first the mezzanine helped me have more open space in the garage, by putting lots of stuff that had been on the floor up on the mezzanine. Unfortunately my wife and I are both pack rats, and now the garage is about as bad as it used to be. The mezzanine is pretty full.
I think the mezzanine was a real good addition to my garage, and well worth the expense and time it took me to build it. The only thing I would advise is to build yours lots stronger than you need to, and attach it to the wall very well, supported by a ledger board. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
