Stranded copper wire (improved flexibility and vibration resistance) of sufficient ampacity (like 12 Gauge if thats what you have) is okay to use and, of course, any splices need to be inside a junction box in an accessbile location. If you use a metallic box (covered, and use romex clamps or other appropriate entrance and exit), be sure to also ground the box itself to the equipment GroundING Conductor (the bare or green wire). They make those short copper ground jumper wires with the green grounding screw attached that works to ground the boxes. Or use a blue plastic box no grounding required.
I agree with the posts below, when using wire nuts on sold wire a few good tight twists of the still insulated portions of the wire just outside the nuts better secures the wires inside. I like the heavier solid plastic wire nuts versus the thinner flexible type in locations where strength is important, if they are tightened down and the wires well twisted outside the nut, that makes for a secure connection.
GFCI is required for outdoor locations which could be a GFCI outlet itself or if its fed by a GFCI upstream or a GFCI breaker etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.