Posted by jackinok on August 07, 2012 at 11:59:15 from (162.58.82.136):
In Reply to: Electrical Problem posted by Michael J. on August 07, 2012 at 10:17:25:
if this uses a regular can coil like is on a auto,youll be money ,time, and agravation ahead by simply walking into any parts store and telling them you want a 12 volt coil that uses no ignition resistor. if you dont want to go this route no one here can say unless we know the resistance of your existing coil,OR the new one you buy since yours is likely now bad. the idea is to simply limit the amp draw on your coil to a level it can handle without over heating. you typicaly will want a amp draw of around 3.5 amps or so on your ignition for long life and performance,so youll want a total ignition circuit resistance of around 4 ohms.this may be high a little but your alternator is putting out around 14.5 volts instead of 12. if you calculate it on straight 12 volts youll want a resistance of your total ignition circuit of @3.5ohms .so measure your coil(its MY opinion you should buy new as i believe once one overheats and tractor dies youve damaged it, but you could get by possibly) between the two small posts,find a external resistor to make your total resistance in ignition circuit between 3.5 and 4 ohms and you should be pretty close. as you can see, a coil that needs no resistor is far less complicated far less connections to go bad etc,but its your call .thats the theory behind the resistor anyway, i hope this helps!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.